Mitsubishi MELSEC-A series - Page 48

3. SPECIFICATIONS /MELSEC-A
(4) Inching enable area (X axis: address 47, Y axis: address 347)
Enable the manual pulser inching function by writing a 1 to the least
significant bit in this address. This data may be written at any time.
bltob15maybelorO
(ignored
by OS).
Inching enable = 1
Inching disable = 0
I
Fig. 3.25 Inching Enable
(5) M code comment area (X axis: address 49 to 200, Y axis: 349 to 500)
Up to 16 ASCII characters may be entered as M code comment data
(using the AGGPP or sequence program).
Comments may be written to M code numbers 1 to 19 for both X
and Y axes.
(6) Status area (X axis: address 43, Y axis: address 343)
Is reserved for the information shown in Fig. 3.26 and is set by
the AD71 OS,
b15
-<
-
Set to 0.
Ill I I
Zeroing request I
II I I
During dwell time
____) Zeroing complete
-1
Zeroing dog ON
I
Drive unit ready signal ON
I
Fig. 3.26 Status Area
I POINT1 I
I I
I
i
1
f
i
I Do not write data to this area.
I
3-33
IB INAI 66101.A