Mitsubishi MELSEC-Q/L User Manual

592
S.DATE+, SP.DATE+
(2) If the results of the addition of time exceed 24 hours, 24 hours will be subtracted from the sum to make the final operation
result.
For example, when the time 20:20:20:500 is added to 14:20:30:875, the result is not 34:40:51:375, but 10:40:51:375.
Devices, +3, +3, and +3 are not used for operation.
A clock data read by the S(P).DATERD instruction can be directly added.
Operation Error
(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and an error code is stored into
SD0.
Caution
(1) Specifying digit for the bit device can be used only when the following conditions (a) and (b) are met.
(a) Digit specification: K4
(b) Head of device: multiple of 16
When the above conditions (a) and (b) are not met, INSTRCT CODE ERR.
(error code:4004) will occur.
Error
code
Error details
Q00J/
Q00/
Q01
QnH QnPH QnPRH QnU LCPU
4100
The value set for and is not within the setting range. (See
Function (1).)
––
4101
The range of the device specified by , or exceeds the range of
the corresponding device.
–– –– –– ––
D
S2
S1
+1
+2
+1
+2
+1
+2
+
S1
S1
S2
S2
D
D
Hour: 14
Minute: 20
Second: 30
+3
+3
+3
S1
S2
D
--
+4
+4
+4
S1
S2
D
Millisecond: 875
Hour: 20
Minute: 20
Second: 20
--
Millisecond: 500
Hour: 10
Minute: 40
Second: 51
--
Millisecond: 375
S1
S2
D
+1
+2
+3
Hour
Minute
Second
Day of week
D
D
D
D
Millisecond
When the clock data is read by the S(P).DATERD instruction,
day of week is inserted between "second" and "millisecond".
If the S(P).DATE+ instruction is used to read the clock data,
the data can be directly used for add
ition since it does not perform
the calculation for the day of a week.
+4
D
S1 S2
S1 S2
D

Mitsubishi MELSEC-Q/L Specifications

General

Brand	Mitsubishi
Model	MELSEC-Q/L
Category	Controller
Language	English