654
PUNLOADP
Operation Error
(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and an error code is stored into
SD0.
Program Example
(1) The following program transfers "ABCD.QPG" stored in drive 4 to drive 0 and places the program in standby status when
M0 is turned ON.
[Ladder Mode] [List Mode]
: Character string data of the program file name to be unloaded, or head number of the devices storing the character string data (BIN 16 bits)
: Device turned ON for 1 scan on completion of the instruction (bits)
*1: Local devices cannot be used.
Error
code
Error details
Q00J/
Q00/
Q01
QnH QnPH QnPRH QnU LCPU
2401 The file size of the local devices cannot be reserved. –– –– –– ––
2410
The file name does not exist at the drive number specified in .
The program file which has the same name as the program file to be
loaded already exists.
–– –– –– ––
2413 There is not enough memory to load the specified program in drive 0. –– –– –– ––
4100
The drive No. specified in is invalid.
–– –– –– ––
4101
The same number of files as that indicated in the table below has been
already registered in the program memory.
The program No. stored in SD720 is already used, or is larger than the
largest program No. shown in the table below.
–– –– –– ––
CPU Model Name Program Memory (No. of Files) Largest Program No.
Q02 (H) CPU 28 28
Q06HCPU 60 60
Q12HCPU 124 124
Q25HCPU 124 124
Q12PHCPU 124 124
Q25PHCPU 124 124
7.18.17 PUN LOADP Unlo ading program from program memory
7.18.17
PUNLOADP
Setting
Data
Internal Devices
R, ZR
J\
U\G
Zn
Constants
$
Other
Bit Word Bit Word
–– –– ––
*
1
–– –– –– ––
S
S
Instruction
Device
Step
Basic
Redundant
Universal
LCPU
Process
High
performance
PUNLOADP
Command
PUNLOADP S D
S
D
S
D
To Next Page
Loading...
Need help?
General
