8 - 45
8. DEBUGGING FUNCTION
(b) Setting the break condition
Set the device status and break point at "2. Break Cond" on the "Partial Run"
screen.
The following shows the devices that can be set.
1) Bit device : X, FX, DX, Y, FY, DY, M, L, F, SM, V, B, SB, T (Contact), T
(Coil), ST (Contact), ST (Coil), C (Contact), C (Coil), J \X,
J \Y, J \B, J \SB, BL \S
2) Word device : T (Current value), ST (Current value), C (Current value), D,
SD, FD, W, SW, R, Z, ZR, U \G, J \W, J \SW
To Next Page
Loading...
