8.
8 - 44
DEBUGGING FUNCTION
8.7.2 Partial execution
The sequence program is executed from the start step or the step where operation is
currently stopped to a designated step (break point).
The following shows the procedures to perform partial execution.
All operations are performed on Monitor/test screen in the ladder mode (debugging).
(1) Designate the execution start step, break condition, and execution operation with
GPP function.
(a) Setting the execution start step
Designate the step at which partial execution is started at "1. Partial Run" on the
"Partial Run" screen.
Fig. 8.4 Partial execution
Operation Procedures
To Next Page
Loading...
