App - 137
APPENDICES
4080H
Other error
Data error Data is faulty.
Check the requested data
contents.
4081
H
The searched target cannot be
detected.
Cannot find the find target. Check the data to be searched.
4082
H
The designated command cannot
be performed since it is in
execution.
Unable to execute due to on
going process.
Re-perform the command after
requests from other devices has
been completed.
4083
H
An attempt was made to perform a
program not registered in the
parameters.
Not registered.
Register the program to be
performed to the parameters.
4084
H
The designated pointer P, I cannot
be detected.
Cannot find the find target. Check the data to be searched.
4085
H
Pointer P, I designation is not
possible because the program is
not registered in the parameters.
Not registered.
Register the program to be
performed in the parameters, then
designate the pointer P, I.
4086
H
An attempt was made to add a
pointer P, I that have already
existed.
Device ranges are duplicated.
Check the pointer No. to be added
and change it.
4087
H
The number of pointers
designated is too great.
No pointer exists.
Check and correct the designated
pointer.
4088
H
The designated step No. is not at
the head of the instruction.
Execution position is incorrect.
Check and correct the designated
step No.
4089
H
The END instruction was inserted/
deleted while the CPU module
had been in RUN.
Setting is incorrect.
Insert/Delete the instruction after
setting the CPU module to STOP.
408A
H
The file capacity has been
exceeded by performing write
during RUN.
File capacity is not enough.
Set the CPU module to STOP and
then write the program.
408B
H Cannot perform a remote request. Data error.
Set the CPU module to the state
for performing a remote request,
then reissue the request.
Error Code
(Hexadecimal)
Error Error Contents
Message Displayed
at Peripheral Device
Corrective Action
To Next Page
Loading...
Need help?
General
