Mitsubishi Q2ACPU User Manual

App - 138
APPENDICES
4090H
Online
registration
error during
SFC STEP
RUN
Too many block break points. Setting is out of range. Check and correct the set number.
4091
H
The number of registered block
break points is incorrect.
Setting is out of range. Check and correct the set number.
4092
H Too many step break points. Setting is out of range. Check and correct the set number.
4093
H
The number of registered step
break points is incorrect.
Setting is out of range. Check and correct the set number.
4094
H
An attempt was made to perform a
request during block continuous
processing.
Unable to execute due to on
going process.
Reissue the request after the
processing has been completed.
4095
H
An attempt was made to perform a
request during block forced
execution processing.
Unable to execute due to on
going process.
Reissue the request after the
processing has been completed.
4096
H
An attempt was made to perform a
request during step continuous
processing.
Unable to execute due to on
going process.
Reissue the request after the
processing has been completed.
4097
H
An attempt was made to perform a
request during step forced
execution processing.
Unable to execute due to on
going process.
Reissue the request after the
processing has been completed.
4098
H
An attempt was made to perform a
request during one step
continuous processing.
Unable to execute due to on
going process.
Reissue the request after the
processing has been completed.
4099
H
An attempt was made to perform a
request during one step forced
execution processing.
Unable to execute due to on
going process.
Reissue the request after the
processing has been completed.
409A
H
An attempt was made to perform a
request during block forced end
processing.
Unable to execute due to on
going process.
Reissue the request after the
processing has been completed.
409B
H
An attempt was made to perform a
request during step forced end
processing.
Unable to execute due to on
going process.
Reissue the request after the
processing has been completed.
409C
H
An attempt was made to perform a
request during holding step reset
processing.
Unable to execute due to on
going process.
Reissue the request after the
processing has been completed.
409D
H
A block No. with no created block
or out-of-range block No. has
been designated.
Setting is incorrect.
Check and correct the set
contents.
409E
H
A step No. for which no step has
been created was designated.
Setting is incorrect.
Check and correct the set
contents.
409F
H
The designated number of cycles
is out of range.
Setting is out of range. Check and correct the set number.
Error Code
(Hexadecimal)
Error Error Contents
Message Displayed
at Peripheral Device
Corrective Action

Mitsubishi Q2ACPU Specifications

General

Brand	Mitsubishi
Model	Q2ACPU
Category	Controller
Language	English