Mitutoyo AT211 - 3.3 Mounting the Detector and Adjusting the Position

20
3 Installation onto the Machine Main Unit
No. 99MBE011A
3.3
Mounting the Detector and Adjusting the Position
After completing the steps described in "Mounting the Scale Main Unit and Adjusting the Position",
follow the procedures below to install the Detector.
3.3.1 Mounting the Detector
1
Check the parallelism of the Detector mounting surface.
For details, see "4.6 External View and Dimensional Drawings of the Scale Main Unit" (page 38)
2
Temporarily x the Detector with the supplied detector xing screws.

Fixing at multiple points
Fixing screw M4 x 25
Use a spring washer and plain washer.

Fixing at both ends
Fixing screw M4 x 25
Use a spring washer and plain washer.