Mitutoyo AT211 - Assembly of D-Sub Connector

30
4Specication
No. 99MBE011A
When assembling the D-sub connector, make sure to conduct electricity from the cable shielded wire
to the metal shell. Also, peel part of the sheath (coating) of the cable on the NC device and make sure
to use the ground bar to ground the shielded wire.
Ground bar etc.
Feedback cable
Shielded wire (mesh wire)
Partially cut coating of the cable
4.4.2 Assembly of D-Sub Connector
1
Cut the sheath (coating) of the cable material into the length of the following gure.
Make sure not to damage the internal shielded wire.
Cable material (coating) Shielded wire
2
Untangle the exposed shielded wire to spread radially and cut it against the sheath.
Shielded wire
3
Peel the tip of the coating of the wire about 3 mm, and make a preliminary solder after twisting the
conducting wires.
Pre-soldering the tip
4
Solder each line to D-sub connector (socket contact, 15 pins/supplied accessory).