Mobotix Mx-M26B - Boot Options of the Camera

70
M26 Camera Manual: Operating the Camera
3.2.4 Start Options of the Camera
By default, the camera starts as DHCP client and automatically tries to get an IP address
from a DHCP server. To start the camera in a mode dierent from the default mode, you can
activate the boot menu of the camera.
Preparing the Camera
• Disconnect the camera’s power supply.
• Make sure that you have suitable item such as a paper clip at hand,
but never use
sharp or pointed objects!
• Reconnect the power supply of the camera.
Activating the Boot Menu
The right LED lights up red 5 to 10 seconds aer establishing the power supply and will stay
on for 10 seconds. Briey press the key by inserting the paper clip into the hole indicated
by the red circle in the gure. The camera enters the boot menu, ready for selecting one of
the Start Options.
The LED now ashes once and repeats the ash signal aer pausing for one second (the
number of ashes indicates the current boot option). To go to the next boot option, briey
press the key again (< 1 sec). Aer the last boot option, the camera returns to the rst option
(LED ashes once).
Selecting a Boot Option
Press the key longer (> 2 sec). The camera conrms the selection by ashing rapidly three
times. You can now remove the paper clip. Aer 20 sec, the camera will conrm the selection
by playing a sound according to the table above.
If nothing is selected, the camera will resume its normal boot process aer a certain time.
Key
1
2
LED default settings:
1 Power (on),
Error (ashing)
2 Recording (ashing)
LED
ashes
Boot
Option
Meaning
Audio
Conrmation*
1 x — This option is not used on this camera model. —
2 x
Factory
Defaults
Starts the camera with factory defaults (factory default IP address,
users and passwords will not be reset).
Boing
3 x
Automatic IP
Address
Starts the camera as DHCP client and tries to obtain an IP address
from a DHCP server. If a DHCP server cannot be found or no IP address
can be obtained, the camera starts with its factory default address.
Boing Boing
4 x
Recovery
System
Starts the camera with the recovery system, e.g., in order to recover
from a failed update of the camera soware.
Alarm Sound
*Only on cameras with audio option and installed speaker.