Mobotix Mx-M26B - Password for the Admin Menu

94
M26 Camera Manual: Operating the Camera
Depending on the later tilt of the camera, drill through the front or rear drain hole of the
camera’s weatherproof housing.
When cleaning the camera with a water jet, do not use high-pressure cleaners. The drain
holes should be sealed with adhesive tape during cleaning.
3.6.2 Password for the Admin Menu
Accessing the Administration Menu of the camera (Admin Menu sobutton) is only possible
aer entering a user name and password.
• Factory default user name is
admin .
• Factory default password is
meinsm .
(Note that you need to change the password upon your rst login – camera release V5.1.x
and higher.)
The Quick Installation assistant automatically appears when the Administration Menu is
accessed for the rst time. It provides an easy method to adjust the basic camera settings to
the current application scenario. For security reasons, we highly recommend changing the
default administrator password aer the camera has been properly congured.
Enter the user name and password exactly as shown above. Note that all entries are case-sen-
sitive.
Caution
Make sure that you store information on user names and passwords in a secure place.
If you lose the administrator password and cannot access the administration menu,
the password can only be reset at the factory. This service is subject to a fee!
TILT (UP)
TILT (DOWN)
Camera tilted upwards: Drill
through rear drain hole
Camera tilted down-
wards: Drill through
front drain hole