Operating Instructions
source. If green, then that source is powering the CT100. If red, then that source is being
charged.
Batteries and long-term storage
The CT100 has NiMH internal batteries. These batteries will drain if the CT100 is left in
storage over long periods.
To preserve battery charge for as long as possible during storage, make sure the power switch
on the back of the CT100 is set to the OFF position.
After several months of storage, the internal batteries may be completely drained. Allow up to
24 hours for the first re-charge of the CT100 after coming out of long-term storage.
Low battery
When a low battery condition is first encountered, the CT100 alerts the user with a red
warning. An “Internal Battery Low” message appears when the battery percentage left drops
below 20 percent.
Mohr CT100 / CT100HF Operator's Manual 11