Mohr CT100 - Page 23

Operating Instructions
17) AUTOFIT button. The AUTOFIT function displays the cable connected to the unit from the
BNC connection to the end of the cable terminated by either a short or an open or by the location
of the last cursor position. This functionality allows the user to immediately display an entire
cable, compressed to fit on the screen. The user can then position the active cursor over the
location of interest and expand the scale to zoom in.
18) M-FUNC (multifunction) button. The function of the M-FUNCTION knob (19) is set by this
button. The current operation is displayed on the screen.
19) M-FUNCTION (multifunction) knob. This knob adopts the function selected through the use
of the M-FUNC button (18).
20) V1 function button. Function depends on menu.
21) V2 function button. Function depends on menu.
22) V3 function button. Function depends on menu.
23) V4 function button. Function depends on menu.
14 Mohr CT100 / CT100HF Operator's Manual