Molift Rail System (MRS)
Introduction
Molift Overhead Systems consist of a rail system,
Molift Rails System (MRS) combined with the lift
motor choices Molift AIR or Molift Nomad which
give innovative and efficient solutions when it
comes to lifting needs for disabled persons.
Molift Overhead Systems are easy and safe to use
and can solve most lifting situations. The func-
tional and user friendly design provides greater
access to the user and increases assistant and user
safety. Molift solution gives a highly flexible, inno-
vative, cost effective and profitable investment.
This handbook provides support and guidance to
installation performance of Molift overhead lift
systems and contains important information about
the design criteria and installation solutions. It is
important to thoroughly understand the content
of the handbook.
Conditions of Performing Installation
Lift and transfer of a person will always pose
a certain risk and only certified personnel are
allowed to install the equipment and accessories
covered by this technical manual.
Only personnel authorized by Etac
can perform installation of the
Molift overhead system and issue
the installation certificate, all in
accordance with Etac’s installation
instructions and this handbook.
The lifter is not intended to be operated by the
person being lifted. If a hoist is to be used by a
disabled person living on their own, then some
form of communication device shall be installed
in the area of use of the hoist so that in the event
of an emergency the disabled person is able to
summon assistance. This may, for example, be
the fitting of an alarm system or the supply of a
conveniently placed telephone, etc.
General
Declaration of conformity
The Molift Rail System and related accessories described in this handbook are CE marked
in accordance with EU Council Directive 93/42/EEC concerning medical devices, class 1, and
is manufactured in conformity with standards IEC 60601-1, IEC 60601-1-2 and NS-EN ISO
10535:2006.
Components made by other manufacturers
We recommend only using Etac Molift components. Etac shall not be liable for faults or accidents
that can occur when using components made by other manufacturers.
System should consist of only original MRS components. If not Decalaration of
conformity is not valid and Etac is not responisble for warranty of the system
To Next Page
Loading...
