End Stops
End stop is an important safety detail for all
Overhead systems. All rail ends must have an End
stop to prevent trolleys from going out of the rail.
The end stop can also be used to limit the range
of lifting area.
45mm
Ø11
Use drill guide 1109998 to mount end stop.
Pos. Article no.
1 1109410 End stop for motor trolley
2 110 9 411 End stop for traverse trolley
Check to ensure that the end stops
are assembled into all rail ends in
the overhead system.
End caps
Plastic caps for covering rail ends. Comes in two
colours for all three different rail heights, grey and
white. (for combination with anodized or white
rails)
Article no.
110 9320 End Cap Rail H62 Grey
110 9321 End Cap Rail H12 Grey
110 9322 End Cap Rail H142 Grey
110 93 4 0 End Cap Rail H62 White
110 93 41 End Cap Rail H112 White
110 93 42 End Cap Rail H142 White
White plastic sleeve
To be used as cover for ceiling bracket when going
through false ceiling.
Article no.
For threaded rod system:
1120338 Sleeve LKF62/28,5/7 White
For telescope bracket (upper part):
110 9 817 Sleeve RKW 1 1/2-50 White
4.3 End Stops and End Caps
1 2
To Next Page
Loading...
