Page 49 of 110
Rev. G
4. If you are using a Customer Supplied PI Server, enter the PI Server Port
Number. If you are using MonicoLive, it will be filled in and un-editable.
5. The PI Server Producer Token is a security code for the data to be able to get
into the PI Server. If you are using MonicoLive we will either fill this in before
shipping or email this to the customer for them to put in onsite. If this is a
Customer Supplied PI Server application, contact your PI administrator to get a
Producer Token.
6. Data compression is set to default ON. We recommend using compression but
can be turned off if desired. The amount of data sent will increase by
magnitudes of 200% or more potentially.
7. Data Transmission Efficiency is a setting that will help reduce data usage. This
is applicable when using cell modems and satellite connections. We
recommend starting at 2 and working your way up until you are happy with
the performance. Ranges from 2 - 10.
8. Max Buffer Size is the amount of space allocated on the unit to buffer data if
the network cable is disconnected, or cell modem drops out. mCore will
continue to retrieve data and store it until the connection is re-established.
We recommend leaving this setting at the default unless your application will
be doing a lot of logging. Once the connection is back, mCore will send the
stored data. Depending on how long the connection was down and the speed
of the connection, will determine how long it will take to backfill the data to
the PI Server.
9. Click the Store Changes button in the center menu when done.
To Next Page
Loading...