Moog Matriarch User Manual

64
(Continued)
Global Parameters
Group 1
Group Select
Key
Parameter
Select Key
Sync Enable
Button Blinks
1.5 MIDI Clock Input C#2 A#0 1 x / 5 x
The Matriarch Sequencer and Arpeggiator can be set to follow MIDI Clock, and can respond to Start and Stop
commands received via MIDI. Depending on your setup, you may wish for Matriarch to ignore some of these
commands. Use the first three white keys to select FOLLOW MIDI CLOCK + MIDI START/STOP COMMANDS (C0),
FOLLOW MIDI CLOCK ONLY (Ignore MIDI Start/Stop commands) (D0), or IGNORE ALL MIDI CLOCK + MIDI
START/STOP COMMANDS (E0). The Default is FOLLOW MIDI CLOCK + MIDI START/STOP COMMANDS.
1.6 MIDI Clock Output C#2 C#1 1 x / 6 x
The Matriarch Sequencer and Arpeggiator can be set to output MIDI Clock, as well as MIDI Start and Stop
commands. Depending on your setup, you may wish for Matriarch to not send some of these commands. Use
the first three white keys to select SEND MIDI CLOCK + MIDI START/STOP COMMANDS (C0), SEND MIDI
CLOCK ONLY (Do not send MIDI Start/Stop commands) (D0), or DO NOT SEND MIDI CLOCK + MIDI START/
STOP COMMANDS (E0). The Default is SEND MIDI CLOCK + MIDI START/STOP COMMANDS.
1.7 Local Control (Keyboard) C#2 D#1 1 x / 7 x
The Matriarch Keyboard, Pitch, and Modulation wheels can be disconnected from the internal synth engine,
while still outputting MIDI and CV/Gate data. Use the lowest two white keys to select Local Control (Keyboard)
OFF (C0), or ON (D0). The Default is ON.
1.8 Local Control (Arp / Seq) C#2 F#1 1 x / 8 x
The Matriarch Arp / Sequencer module can be disconnected from the internal synth engine while still
outputting MIDI and CV/Gate data. Use the lowest two white keys to select Local Control (Arp / Seq) OFF
(C0), or ON (D0). The Default is ON.
1.9 Receive Program Change C#2 G#1 1 x / 9 x
MIDI Program Change commands (Program Numbers 1 through 12) can be used to load a previously saved
Matriarch sequence, and make it the active sequence. Turning this Global Setting OFF will prevent errant
Program Change commands from inadvertently activating a saved sequence. Use the lowest two white keys
to select OFF (C0), or ON (D0). The Default is ON.
1.10 Send Program Change C#2 A#1 1 x / 10 x
Matriarch can be set to send a MIDI Program Change command (Program Numbers 1 through 12) when the
OCT / BANK switch and SEQUENCE knob on the front panel are used to select and load a previously saved
sequence from memory. Turning this Global Setting OFF will prevent Program Change commands from being sent
when a sequence is selected. Use the lowest two white keys to select OFF (C0), or ON (D0). The Default is OFF.

Moog Matriarch Specifications

General

Product type	Analog synthesizer
Sound effects	Delay
Sound effects quantity	1
Keyboard number of keys	49
Maximum polyphony (notes)	4
MIDI in	Yes
6.35 mm (1⁄4-inch) input	3
6.35 mm (1⁄4-inch) output	2
Input voltage	240 V
DC input voltage	12 V
Power source type	DC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Depth	361 mm
Width	810 mm
Height	139 mm
Weight	13610 g