7-24 Disassembly/Reassembly Procedures: Radio Reassembly
7.6.5 Reassemble the Keypad Retainer (27)
1. Place the Keypad Retainer (27) over the Keypad Board (26) in the Front Housing (16) as
shown in Figure 7-33.
Figure 7-33. Place Keypad Retainer over the Keypad Board
2. Torque all four keypad retainer screws (28) with a Torx IP6 Bit and a Torque Driver to
1.2 in-lbf in the sequence as shown in Figure 7-34.
Figure 7-34. Torque in the Keypad Retainer Screws
To Next Page
Loading...
