8-30 Disassembly/Reassembly Procedures: Radio Reassembly
8.6.5 Reassemble the Keypad Retainer (34)
1. Place the Keypad Retainer (34) over the Keypad Board (35) in the Front Housing (19) as
shown in Figure 8-40.
Figure 8-40. Place Keypad Retainer over the Keypad Board
2. Torque all four keypad retainer screws (33) with a Torx IP6 Bit and a Torque Driver to 1.2 in-lbf
in the sequence as shown in Figure 8-41.
Figure 8-41. Torque in the Keypad Retainer Screws
To Next Page
Loading...
