NEXT > < PREV CONTENTS
ADVANCED FEATURES
Emergency Operation
Sending an Emergency Alarm and Call with Hot Mic
139
This feature allows you to send an Emergency Alarm
and Call with hot mic to a group of radios.
Your radio must be programmed for this type of
operation.
Procedure:
1. Press the preprogrammed Emergency button.
If successful, the display shows EMERGENCY on
the current zone and channel. A tone sounds and
the LED blinks red momentarily.
The radio exits Emergency Alarm and enters the
Emergency Call state when one of the following
scenarios occur:
• You receive the dispatcher acknowledgement.
The display shows Ack received.
• You receive no acknowledgement. The display
shows No acknowledge.
2. Hold the microphone vertically 1 to 2 inches (2.0
to 2.5 cm) from your mouth.
3. The microphone remains active for the hot mic
time specified in your radio's codeplug
programming.
4. To exit Emergency Call, press and hold the
preprogrammed Emergency button.
Turning off the radio also cancels the emergency
state.
To Next Page
Loading...
