NEXT > < PREV CONTENTS
ADVANCED FEATURES
Multiple Control Head Features
99
This feature allows your transceiver to control the combinations of control heads on APX Mobile.
You can use the Controller Area Network (CAN) cables to connect in any configuration that does not exceed
131 feet (40 meters) in combined length. For further information, refer to the following Installation Manuals:
• 6878215A01 APX Mobile Radios and Control Heads Installation Manual
• MN003109A01 APX 8500 Mobile Radio Installation Manual
• MN005720A01 Enhanced Single Band Mobile Radio Installation Manual
The Multiple Control Head (MCH) feature consists of 2 modes that can be programmed via Customer
Programming Software (CPS):
• All Active mode
• One Active mode
Note: If two or more control heads are connected to the system before enabling the MCH feature in the CPS,
the radio will display Extra CH or CH ID # ERR. Both errors are FATAL.
To Next Page
Loading...
