NEXT > < PREV CONTENTS
GETTING STARTED
Preparing Your Radio for Use
Validating Compatibility During Power Up
33
The radio validates and updates the software and hardware of your control head(s) during power up. During
validation, the display shows Maintenance Mode Remote Device promptly followed by other maintenance
statuses.
Procedure:
When the display shows Update done Please reset upon completion, press the Power On/Off Button to
reset:
OR
When the display shows Update failed Please reset when it fails to update, press the Power On/Off Button
to reset.
If the software updates are completed, the radio runs the usual power-up operation.
If the updates are incomplete, the radio runs the Maintenance Mode and the display shows Maintenance
Mode Remote Device; promptly followed by other maintenance statuses again.
To Next Page
Loading...
