8 - 2 Symbol LS3408 Product Reference Guide
Connecting to an IBM 468X/469X Host
The scanner connects directly the host.
Figure 8-1
IBM Direct Connection
1. Connect the modular connector of the IBM 46XX interface cable to the cable interface port on the scanner.
(See Installing the Interface Cable on page 1-3.)
2. Connect the other end of the IBM 46XX interface cable to the appropriate port on the host (typically Port 9).
3. Ensure all connections are secure.
4. Select the port address by scanning the appropriate bar code from the Port Address section on page 8-4.
5. To modify any other parameter options, scan the appropriate bar codes in this chapter.
Host Port Connector
Interface cable
NOTE Interface cables vary depending on configuration. The connectors illustrated in Figure 8-1 are examples
only. The connectors may be different than those illustrated, but the steps to connect the scanner are the
same.
NOTE The only required configuration is the port address. The IBM system controls most other scanner
parameters.
To Next Page
Loading...
