14 - 6 Symbol LS3408 Product Reference Guide
Special Commands
Pause Duration
This parameter, along with the Send Pause parameter on page 14-29, inserts a pause in the data transmission. Set
the pause by scanning a two-digit number (i.e., two bar codes) representing a 0.1 second intervals. For example,
scanning bar codes 0 and 1 inserts a 0.1 second pause; 0 and 5 gives a 0.5 second delay. See Appendix D,
Numeric Bar Codes for numeric bar codes. In case of an error, or to change the selection, scan Numeric Cancel
on page D-3.
Pause Duration
Begin New Rule
Scan this bar code to start entering a new rule.
Begin New Rule
Save Rule
Scan this bar code to save the entered rule.
Save Rule
To Next Page
Loading...
