6 - 18 Symbol LS3408 Product Reference Guide
Nixdorf Mode A/B and OPOS/JPOS Beep/LED Options
If you selected Nixdorf Mode A, Nixdorf Mode B or OPOS/JPOS, this parameter indicates when the scanner beeps
and turns on its LED after a decode.
*Normal Operation
(Beep/LED Immediately After Decode)
Beep/LED After Transmission
Beep/LED After CTS Pulse
Ignore Unknown Characters
Unknown characters are characters the host does not recognize. Select Send Bar Codes with Unknown
Characters to send all bar code data except for unknown characters. The scanner sounds and no error beeps.
Select Do Not Send Bar Codes With Unknown Characters to send bar code data up to the first unknown
character. The scanner sounds an error beep.
*Send Bar Code with Unknown Characters
Do Not Send Bar Codes with Unknown Characters
NOTE The Beep/LED After CTS Pulse option is not valid when Nixdorf Mode A is selected.
To Next Page
Loading...
