Advanced Data Formatting 14 - 27
Setup Field(s)
Table 14-1
Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character Scan the
Move Cursor To Character
, then any printable ASCII
character from the
Alphanumeric Keyboard on page 14-95
. This
moves the cursor to the position after the matching character. If the
character is not there, the rule fails and ADF tries the next rule.
14-28
Move Cursor to Start of Data Scan this bar code to move cursor to the beginning of the data.
14-28
Move Cursor Past a
Character
This action moves the cursor past all sequential occurrences of a
selected character. For example, if the selected character is ‘A’, the
cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan the
Move Cursor Past
Character
, then select a character from the
Alphanumeric Keyboard
. If
the character is not there, the cursor does not move (i.e., has no effect).
14-28
Move Cursor Past a Specific
String
This action moves the cursor past the first occurrence of a selected
string. Scan
Move Cursor Past Specific String
, then select the
character(s) (up to 10) using the
Alphanumeric Keyboard
. Scan the
End of Message bar code on page 14-106
.
14-28
Move Cursor to Specific String
and Replace
This action moves the cursor to the first occurrence of a selected string
and replaces the string with another user-defined string. Scan
Move
Cursor to Specific String and Replace
, then enter an alphanumeric
string representing the character(s) (up to 10) to match and delete using
the
Alphanumeric Keyboard
. Scan the
End of Message bar code on
page 14-106
. Enter another alphanumeric string representing the
character(s) (up to 10) to insert using the
Alphanumeric Keyboard
.
Scan
End of Message
.
14-28
Move Cursor to Last
Occurrence of String and
Replace All
This action replaces all occurrences of a selected string with another
user-defined string, and moves the cursor to the beginning of the last
occurrence. Scan
Move Cursor to Last Occurrence of String and
Replace All
, then enter an alphanumeric string representing the
character(s) (up to 10) to match and delete using the
Alphanumeric
Keyboard
. Scan the
End of Message
. Enter another alphanumeric
string representing the character(s) (up to 10) to insert using the
Alphanumeric Keyboard
. Scan
End of Message
.
14-29
Skip to End Scan
Skip to End
to move the cursor to the end of the data.
14-29
Skip Ahead “N” Characters Scan one of these bar codes to select the desired number of positions
to move the cursor ahead.
14-30
Skip Back “N” Characters Scan one of these bar codes to select the desired number of positions
to move the cursor back.
14-32
Send Preset Value Send prefix and/or suffix value by scanning the appropriate bar code.
Set these values using the Scan Prefix and Scan Suffix bar codes on
page 13-4
.
14-33
To Next Page
Loading...
