Chapter 6 RS-232 Interface
Introduction
This chapter provides RS-232 host information for setting up the scanner. Use the RS-232 interfaced to attach the
scanner to point-of-sale devices, host computers, or other devices with an available RS-232 port (i.e., com port).
If your host does not appear in Table 6-2, set the communication parameters to match the host device. Refer to the
documentation for the host device.
Throughout the programming bar code menus, asterisks (
*) indicate default values.
NOTE This scanner uses TTL RS-232 signal levels, which interface with most system architectures. For system
architectures requiring RS-232C signal levels, Motorola offers different cables providing the TTL to
RS-232C conversion. Contact Motorola Enterprise Mobility Support for more information.
*Baud Rate 9600
Feature/Option
* Indicates Default
To Next Page
Loading...
