Wand Emulation Interface 9 - 7
Convert All Bar Codes to Code 39
By default, the Wand Emulation Interface sends data to the host in the symbology decoded. This can present a
problem for customers with older systems that do not recognize some newer symbologies (for example, GS1
DataBar).
Enable this parameter to ignore the decoded symbology, and transmit the data as a Code 39 bar code. Lowercase
characters in the original data stream transmit as uppercase characters. This also allows ADF formatting to occur.
If you enabled Ignore Unknown Characters, a space replaces characters that do not have a corresponding
character in the Code 39 symbology set.
If you disabled Ignore Unknown Characters, if the scanner encounters any characters that do not have a
corresponding character, it emits an error beep and transmits no data.
ADF Note: By default, the Wand Emulation interface does not allow ADF rules to process scanned data. Enabling
this parameter allows ADF rules to process scanned data. See Chapter 14, Advanced Data Formatting.
.
Convert to Code 39 for Wand Host
(Enable)
*Do Not Convert to Code 39 for Wand Host
(Disable)
To Next Page
Loading...
