Symbologies 12 - 27
Code 11
Code 11
To enable or disable Code 11, scan the appropriate bar code below.
Enable Code 11
*Disable Code 11
Set Lengths for Code 11
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Set lengths for Code 11 to any length, one or two discrete lengths, or lengths within a specific
range.
One Discrete Length - Select this option to decode only Code 11 symbols containing a selected length. Select the
length using the numeric bar codes in Appendix D, Numeric Bar Codes. For example, to decode only Code 11
symbols with 14 characters, scan Code 11 - One Discrete Length, then scan 1 followed by 4. In case of an error,
or to change the selection, scan Cancel on page D-3.
Code 11 - One Discrete Length
To Next Page
Loading...
