Miscellaneous Scanner Options 13 - 7
FN1 Substitution Values
The Wedge and USB HID Keyboard hosts support a FN1 Substitution feature. Enable this to replace a FN1
character (0x1b) in an EAN128 bar code with a user-selected value. This value defaults to 7013 (Enter Key).
1. To select a FN1 Substitution Value, scan the bar code below.
Set FN1 Substitution Value
2. Locate the keystroke desired for FN1 Substitution in the ASCII Character Set table for the current host
interface. Enter the 4-digit ASCII Value by scanning each digit in Numeric Bar Codes on page D-1.
3. To correct an error or change the selection, scan Cancel on page D-3.
To enable FN1 Substitution for Wedge, scan the Enable Keyboard Wedge FN1 Substitution bar code on page
5-10.
To enable FN1 Substitution for USB HID Keyboard, scan the Enable USB Keyboard FN1 Substitution bar code on
page 7-9.
Transmit “No Read” Message
Scan a bar code below to select whether or not to transmit a No Read message. Enable this to transmit the
characters NR when a bar code does not decode. Disable this to send nothing to the host if a symbol does not
decode.
Enable No Read
*Disable No Read
NOTE If you enable Transmit No Read, and also enable Symbol Code ID Character or AIM Code ID Character
for Transmit Code ID Character on page 13-3, the scanner appends the code ID for Code 39 to the NR
message.
To Next Page
Loading...
Need help?
General
