Motorola RFS6000 - Schedule-Calibrate

Motorola RF Switch CLI Reference Guide
25-28
25.1.16 schedule-calibrate
 Smart RF Instance
Configures the calibrate schedule parameters
This is used to configure parameters that schedule the automatic configuration of the
Smart RF feature.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
Syntax
schedule-calibrate [enable |interval |start-time]
schedule-calibrate interval <1-366>
schedule-calibrate start-time <HH:MM> <1-31> <1-12>
<2008-2035>
Parameters
Example
RFSwitch(config-wireless-smart-rf)#schedule-calibrate enable
RFSwitch(config-wireless-smart-rf)#schedule-calibrate
interval 2
RFSwitch(config-wireless-smart-rf)#schedule-calibrate
start-time 10:30 1 1
RFSwitch(config-wireless-smart-rf)#
enable
Enables the schedule-calibrate feature. When enabled, the
Smart RF auto calibration feature is performed at the set
interval.
interval <1-366>
Sets the interval in days between each auto calibration
start-time <HH:MM>
<1-31> <1-12>
<2008-2035>
Sets the time and day to start the first auto-calibration.
<HH:MM> is in 24 hours format.