Why does Motorola SYMBOL DS6707 emit a power-up beep after changing USB host type?
If your Motorola Barcode Reader emits a power-up beep after changing the USB host type, it's normal. The USB bus re-established power to the scanner.
Why does Motorola SYMBOL DS6707 emit one high beep when idle?
If your Motorola Barcode Reader emits one high beep when not in use, it's normal if the scanner is in RS-232 mode, a character was received, and the Beep on option is enabled.
What to do if Motorola Barcode Reader aiming pattern does not appear?
If the aiming pattern doesn't appear when pressing the trigger on your Motorola Barcode Reader, consider the following: * Check the power supply: If your configuration requires one, ensure it is properly re-connected. * Verify the host interface cable: Use the correct cable for your setup. * Inspect cable connections: Make sure all interface/power cables are securely re-connected. * Confirm the scanner is enabled: If disabled, consult the technical person in charge of scanning. * RS-232 Nixdorf B mode: Ensure the CTS line is asserted if using this mode. * Aiming pattern status: Enable the aiming pattern if it is disabled.
What to do if Motorola SYMBOL DS6707 Barcode Reader emits 4 short high beeps?
If your Motorola Barcode Reader emits 4 short high beeps during a decode attempt, it indicates that the scanner has not completed USB initialization. Wait several seconds and then try scanning again.
General| Brand | Motorola |
|---|---|
| Model | SYMBOL DS6707 |
| Category | Barcode Reader |
| Language | English |
To Next Page
