92
Setting the Display’s Working Language
From the main menu, select Setup >
Language
.
The display shows the current language
used. You can customize your MTP850 to
operate in English, German, French, Spanish,
Dutch, or in a language defined by your
Service Provider. The default setting from factory is English.
Scroll to the desired language and press
Select. The display
shows the selected language for a few seconds.
Setting Up the Data Function
You can connect the MTP850 to an external device (such as
a laptop or desktop PC). The MTP850 will then be capable of
transmitting and receiving data from the external device. To
connect the MTP850 accessory connector to the external
device, use cable FKN4897. The external device must run an
application complying with the TETRA standards.
From the main menu, select Setup > Data
Setup
.
The display shows the current setting:
•
Voice Only — The MTP850 will receive and
transmit voice calls only.
•
Data Only — The MTP850 acts as a
modem. The MTP850 will reject incoming and outgoing
voice calls (except for Emergency Calls), status and text
messages.
•
Voice & Data — The MTP850 acts as a modem but voice
calls will have priority over data calls and will interrupt
them.
Scroll to the desired setting and press
Select.
In Data Only and in Voice & Data, the Data Connected icon is
displayed after you have connected the MTP850 to the
external device and the MTP850 is ready for data transfer.
Language
Deutsch
Français
English
Select Back
Español
Nederlands
Data Setup
Data Only
Voice & Data
Voice Only
Select Back
6866537D80-A.book Seite 92 Freitag, 29. Juli 2005 4:15 16
To Next Page
Loading...
