86
1. From the contact list, press .
2. Select Capacity.
3. Select the contacts to check. Select Back to exit.
Security
From the main menu, select > Security.
PIN Protect
Network access protection is configured by
your Service Provider:
• No access to network operation
— you can
only send or receive Emergency Calls and
adjust the volume level. Unit lock takes effect at the next
power on.
To protect access to network operation:
1. From the main menu, select > Security >
PIN Protect. On
is highlighted.
2. Press
Select.
3. At the
Code? prompt enter the 4-digit code (factory setting
0000). To avoid disclosure of the code, asterisks are
displayed instead of the code digits. The display will show
the following message:
Unit Locked — you entered the correct code. The display
returns to the Security sub-menu and shows the active
setting:
On.
To unlock the MTP850 before powering off:
1. From the main menu, select > Security >
PIN Protect. Off
is highlighted.
2. Press
Select.
3. At the Code? prompt enter the 4-digit code.The display will
show the following message:
Unit Unlocked — you entered the correct code. The display
returns to the Security sub-menu and shows the active
setting:
Off.
MENU
Security
Change Code
Keylock
PIN Protect
AirEncrypt
K Validity
Select Back
6866537D80-A.book Seite 86 Freitag, 29. Juli 2005 4:15 16
To Next Page
Loading...
