100
• Upon pressing Select, if the Network List is selected, only
this list will attach. If a user list is selected, then both the
Network List and the user list will be attached.
• In some cases part of the groups in the scan list could be
invalid for specific sites. In this case, when the terminal
tries attachment to the list, the infrastructure might partially
reject attachments. The terminal’s display shows: “List
partially attached”.
• When the Network List is empty, it will be displayed as No
List. Selecting No List will display the message No
Selected Scan List.
Viewing the Active Scan List
This sub-menu allows you to view the active scan list (Scan
List 1 in this example).
1. From the main menu, select More > Group Setup > Scan
> Active List
. Press View.
The display will show one of the following states:
• There is a selected, inactive scan list (Scan List 1 is
Not Active). Scanning is off.
• Scanning is off and the Network List is selected (Net-
work List Not Active).
• There is a selected, active scan list. Scanning is on.
Then, the display will show the Scan Lists
sub-menu.
2. Scroll to the required list and press
View to
see the groups that belong to the list.
3. Scroll to the required group and press
View to view the group status (attached or
not attached) and priority (if pre-programmed).
4. Press
Back to return to the previous display. Then, if
required, press
. You can select to delete the group
from the scan list or change its priority.
If the Network List is empty, it will not be displayed.
Scan Lists
Network List
Scan List 1
View Back
MENU
6866537D80-A.book Seite 100 Freitag, 29. Juli 2005 4:15 16
To Next Page
Loading...
