63
GPS Location Service
device (Digital Car Kit or charger etc.).
Scroll to your selection and press
Select to access the next
display.
This estimate of accuracy of the calculated location is only a
very rough estimate and may vary substantially from the
actual accuracy of the approximate location information
reported.
Viewing Your Position
1. From the main menu, select More...>
Location > Position.
2. Scroll to view the entire screen.
This displays the following information about
the last time your location was calculated (if
available):
• The time the location was last calculated
• The latitude expressed in degrees, minutes, and seconds
• The longitude expressed in degrees, minutes, and
seconds
• The number of satellites used to calculate the location. In
general, more satellites make for better accuracy. The
maximum is twelve satellites.
To calculate your location again, press Rfrsh.
It may take your terminal several minutes to complete the
process of determining your location. During this time, a
message usually appears on your terminal’s display stating:
• Insufficient Visible Satellites, or
• Insufficient Visible Data
For tips on getting the best location calculation, see
“Enhancing GPS Performance” on page 61.
• The variation will vary in accordance to the GPS Configuration
set by your Service Provider.
• The availability of the GPS Location menus is dependent on
your terminal configuration, please contact your Service
Provider for further details.
Position
<Latitude>
<Time>
Rfrsh Back
<Longitude>
<Tracked satellites>
6866537D80-A.book Seite 63 Freitag, 29. Juli 2005 4:15 16
To Next Page
Loading...
