35
TMO Group Call
In addition, your Service Provider might configure the rotary
knob as follows:
• End-Stop Rotary Knob Scrolling — the rotary knob will
stop when it reaches the last group in the folder, and a
tone will alert you that you have reached the last group in
the folder. Use the navigation key to continue scrolling
through the list.
Activating/deactivating Scanning
See “Setting Group Scanning” on page 98.
Making a Group Call
1. From the Home display and if this is the re-
quired group, press and hold the PTT.
2. Wait for the talk permit tone (if configured)
and then speak into the microphone.
Release the PTT button to listen.
When you start a call, all members of the
selected group who have their units turned
on, will receive the Group Call.
Receiving a Group Call
General
Unless it is engaged in a call, your MTP850 will receive the
Group Call.To answer the call, press and hold PTT.
Your MTP850 shows the Group name and the caller’s private
number or name if previously stored in your contact list.
If you are in an on-going Group Call and wish to
make a new call, press to ignore the current
call. Start the new call.
The “No Group” message is displayed when you are out of the
normal coverage area of your selected group. You must then select
a new group that is valid for your working location.
Network 1
Optns Contcs
Folder 1
Police
Hello
Group In Use
Folder 1
Optns Folder
TG4
6866537D80-A.book Seite 35 Freitag, 29. Juli 2005 4:15 16
To Next Page
Loading...
