101
The Menu
Editing Scan Lists
1. From the main menu,
select More > Group
Setup > Scan > Scan
Lists
.
2. Scroll to the required
scan list. Press
View to see the groups used in the scan list.
Press
Back to return to the previous display.
3. To edit/view the contents of a scan list, press
.
4. In the List Optns sub-menu, scroll to the required option
and press
Select.
• Rename the active scan list. (For details on text editor
use, see “Writing Text” on page 121). Enter a new name
(alias) and press
Ok. The display shows the new setting.
•Check
the capacity of the active scan list (number of
groups stored in the list).
•To
Clear all groups from the selected scan list, press
Yes. You will be prompted to remove all groups from the
selected scan list.
•
Add a group to the selected scan list. Every added
group (including a favourite group) comes with its folder,
its name or number, and its priority (if pre-programmed).
> To select a folder, scroll through the folder list. The list
does not show folders whose groups are fully used in
the selected scan list. Press
Ok to select a folder.
> To select a group, scroll through the group list within
the selected folder. The list shows groups that are not
in the selected scan list. Press
Ok.
> To set a priority to a group, scroll through the priority
list: high, medium, or low.
A call from a high priority group will interrupt an on-
going call with a medium and low priority.
The options below cannot be used for the Network List.
• If the Network List is empty, it will not be displayed.
Scan Lists
Scan List 2
Scan List 1
View Back
Network List
List Optns
Capacity
Rename
Select Back
Clear List
Add Group
Edit
MENU
6866537D80-A.book Seite 101 Freitag, 29. Juli 2005 4:15 16
To Next Page
Loading...
