5
5. Activating the EtherNet/IP Function
The ioLogik E1200 series will support the EtherNet/IP protocol after it has been registered and activated. In this
chapter, we explain how to activate the EtherNet/IP function in the ioLogik E1200 series. The EtherNet/IP
function can only be activated for firmware and utility versions that are the same as or more recent than those
listed below.
Firmware:
• ioLogik E1210 V2.5 (std. version)
• ioLogik E1211 V2.4 (std. version)
• ioLogik E1212 V2.5 (std. version)
• ioLogik E1213 V2.6 (std. version)
• ioLogik E1214 V2.5 (std. version)
• ioLogik E1240 V2.4 (std. version)
• ioLogik E1241 V2.5 (std. version)
• ioLogik E1242 V2.5 (std. version)
• ioLogik E1260 V2.5 (std. version)
• ioLogik E1262 V2.5 (std. version)
Utility:
• ioSearch V1.15 (std. version)
To Next Page
Loading...
Need help?
General
