MRC DXL5000 RX - Receiver Controls and Connectors

Operation 2-3DXL5000 User and Technical Manual
POWER IN Connector The POWER IN power connector
provides connection to the removable external power cable. The
power connector assembly also contains the AC power fuse.
MGMT Connector The RJ-45 MGMT connector provides 10
Base T Ethernet connection for remote control.
IF IN Connector The 75 ohm BNC female IF IN connector
provides the 70 MHz IF input to the unit.
SUMMARY ALARM Connector The DB-15 female SUMMARY
ALARM connector provides summary alarm data for common
faults and events.
CHAN1 and CHAN2 DATA Connectors The CHAN1 and
CHAN2 DATA RJ-45 connectors provide 10/100 Base T
Ethernet connections to the unit.
CHAN1 and CHAN2 T1/E1 Connectors The CHAN1 and
CHAN2 T1/E1 RJ-45 connectors provide T1/E1 input
connections for channels 1 and 2.
ASI/DS3/E3 1 and 2 Connectors The ASI/DS3/E3 1 and 2
BNC 75 ohm female connectors provide ASI or DS3/E3 inputs to
the unit.
RESET Switch When the RESET switch is pressed and held for
approximately 5 seconds, the IP address is reset to the factory
default IP address of 192.168.0.10, the subnet mask is reset to
the factory default subnet mask of 255.255.255.0, and the
default gateway is reset to the factory default subnet mask of
192.168.0.1. No other password or configuration settings are
effected.
RF OUT Connector The SMA 50 ohm female RF OUT
connector provides connection from the internal RF circulator to
the external antenna.
ASI/SMPTE310 Connector The 75 ohm BNC female ASI/
SMPTE310 connector provides ASI or SMPTE310 inputs to the
unit.
WAYSIDE DATA Connector The WAYSIDE DATA DB-9 male
connector provides RS-232 connections for SCM operations.
IMC BUS Connector (Reserved for future use.)
IF MON Connector The 75 ohm BNC female IF MON
connector provides a 70 MHz output for external signal
monitoring purposes.
2.2.2 DXL5000 Receiver Controls, Indicators,
and Connectors
Controls, indicators, and connectors contained on the DXL5000
System Receiver are shown in Figure 2-2 on page 2-4 and are
described in the following paragraphs.