MRC DXL5000 RX - Review Receiver Alarms

Operation 2-23DXL5000 User and Technical Manual Operation 2-23DXL5000 User and Technical Manual
2.6.3 Review Receiver Alarms
To review DXL5000 System Receiver alarms and to setup alarm
monitoring options, see Figure 2-16. To review current alarm
status, first select the Alarm tab and then select the Information
tab. To select alarm monitoring options, select the Configure
option button for the corresponding status option.
Figure 2-16: Review Alarms
Select Alarms Tab
Select Help Tab
CH3 FIFO:
Observe
CH3 FIFO
status
RSL:
Observe
RSL status
Fade Margin:
Observe
Fade
Margin
status
CH0 FIFO:
Observe
CH0 FIFO
status
CH2 FIFO:
Observe
CH2 FIFO
status
CH1 FIFO:
Observe
CH1 FIFO
status
PLL Status:
Observe PLL
Status
Indication
Calc:
Observe
Calc status
Code:
Observe
Code status
Select Configure
option button, as
required
Note:
Each of the Information tab status
options may be configured using the
corresponding Configure option
button. Select the corresponding
Configure option button for each
status option, as required.
Select
Information Tab
Select Log Tab
Observe current
Alarm history
Carrier:
Observe
Carrier
status
Power
Supply:
Observe
Power
Supply
status
SCD CH0:
Observe
SCD CH0
status
SCD CH1:
Observe
SCD CH1
status
SCD CH2:
Observe
SCD CH2
status
SCD CH3:
Observe
SCD CH3
status
Status options
displayed
Select Severity
Major, Minor, or
Disabled radio
button option, as
required
Select Type
Alarm or Alert
radio button
option, as
required
Select Latch On
or Off radio
button option, as
required
Select Save
option button
Status Options - Typical
Note:
When the Save option button is selected, the
Severity, Type, and Latch options will be
entered into the radio software.
If changes have been made to the Severity,
Type, or Latch options, selecting the Quit
option button will cancel the changes to the
Severity, Type, and/or Latch options.