Installation 4-2DXL5000 User and Technical Manual
• Check that no front panel LCDs are broken, damaged, or
loose.
• Check that the 4-digit LCD display has not been
damaged.
4.4 Damage in Shipment
Should any damage be discovered after unpacking the unit, use
the following procedure:
• Immediately file a claim with the shipping carrier.
• Forward a copy of the damage report to MRC Customer
Service.
• Contact MRC Customer Service to determine the
disposition of the equipment.
4.5 Installing the DXL5000 System
Each installation or deployment will have its own specific tasks
according to the application and the installed hardware. The
following sections describe mounting and cabling the DXL5000
System Transmitter and Receiver.
The DXL5000 System Transmitter and Receiver are typically
mounted in a standard 19-inch (48.3 cm) rack. The cabling is
permanently installed and power comes from the facility or site
power source.
4.5.1 Site Preparation
The following requirements are designed to make initial
installation easier and to allow room for future access and
servicing.
Equipment Rack The DXL5000 Transmitter and Receiver each
mount into the mounting rails of a standard 19-inch (48.3 cm)
equipment rack. Each unit occupies 1 rack unit (1RU) of height.
• Make certain the rack and mounting rails are strong and
rigid enough to support the DXL5000 Transmitter and
Receiver and the rest of the equipment in the rack.
• The rack should be securely attached to a solid surface
such as a floor or wall to prevent movement or tipping
over.
• Position the rack to allow easy access to the front and
rear of the equipment.
• Be sure to allow room behind the equipment rack for the
many cables required. The cables should not be pressed
against the rear of the equipment when closing doors.
This will stress the cables and may shorten their life.
4.5.2 Mounting the DXL5000 Transmitter and
Receiver
Mounting the DXL5000 Transmitter or Receiver into an
equipment rack is easier if one person holds the unit while
another person installs the mounting screws.
WARNING
Follow instructions carefully.
Exercise care to avoid equipment damage
or personnel injury.
1. Lift the DXL5000 Transmitter or Receiver into place,
lining up the mounting holes with the holes in the rack
mounting rails. See Figure 4-1 on page 4-3.
To Next Page
Loading...