MRC DXL5000 RX - Perform DXL5000 System Transmitter Setup

Operation 2-13DXL5000 User and Technical Manual Operation 2-13DXL5000 User and Technical Manual
2.5.2 Perform DXL5000 System Transmitter
Setup
To set up DXL5000 System Transmitter operating settings, first
select the Setup tab and then select the Identification tab,
Radio tab, and Modulator tab, as required. See Figure 2-6.
Figure 2-6: Setup Tab Options - Sheet 1
Select Setup Tab
Select Help Tab
Select
Identification
Tab
Date Installed:
Enter Date
Installed, as
required
Default Gateway:
Enter new
Default Gateway
address, as
required
Select Submit
option button and
power-cycle radio
Call Sign:
Enter Call Sign,
as required
IP Address:
Enter new IP
Address, as
required
Site Name:
Enter Site Name,
as required
Subnet Mask:
Enter new
Subnet Mask
address, as
required
User
Information 1
Enter data, as
required
User
Information 2
Enter data, as
required
User
Information 3
Enter data, as
required
Select Submit
option button
Select Radio Tab
Select Power Amplifier
On or Off radio button,
as required
A
Note:
After setting addresses, the Submit
option button must be selected and the
radio power must be cycled from on to
off. The radio does not need to be
power-cycled when other options are
changed.
Select Submit
option button
Note:
Select the Submit option button to send
settings to the radio or select the Reset
option button to clear the current
settings on the individual tabs.
Select Test Tone On
or Off radio button, as
required
Select IF Input Internal
or External radio
button, as required
To Figure 2-7
on page 2-14