MRC DXL5000 RX - Review Transmitter Alarms

Operation 2-16DXL5000 User and Technical Manual Operation 2-16DXL5000 User and Technical Manual
2.5.3 Review Transmitter Alarms
To review DXL5000 System Transmitter alarms and to set up
alarm monitoring options, see Figure 2-9. To review current
alarm status, select the Alarm tab and then select the
Information tab. To set alarm monitoring options, select the
Configure option button for the corresponding status option.
Figure 2-9: Review Alarms - Sheet 1
Select Alarms Tab
Select Help Tab
CH3 FIFO:
Observe
CH3 FIFO
status
RF Out:
Observe RF
Output
status
IF Input:
Observe IF
Input status
Fan:
Observe
Fan status
indication
CH0 FIFO:
Observe
CH0 FIFO
status
CH2 FIFO:
Observe
CH2 FIFO
status
CH1 FIFO:
Observe
CH1 FIFO
status
PLL Status:
Observe PLL
Status
Indication
Calc:
Observe
Calc status
Code:
Observe
Code status
Select Configure
option button, as
required
A
Note:
Each of the Information tab status options may be
configured using the corresponding Configure option
button. Select the corresponding Configure option
button for each status option, as required.
Select
Information Tab
Select Log Tab
Observe current
Alarm history
PA Voltage:
Observe PA
Voltage:
status
Power
Supply:
Observe
Power
Supply status
indication
ASI BNC1:
Observe ASI
BNC1 status
ASI BNC2:
Observe ASI
BNC2 status
ASI BNC3:
Observe ASI
BNC3 status
T1 RJ45-1
Observe T1
RJ45-1
status
To Figure 2-10
on page 2-17