Installation 4-5DXL5000 User and Technical Manual
CAUTION
Be sure the power being supplied matches
the power required by the equipment.
CAUTION
Power supply cords and cables must be
protected. Do not run cords where they can
be walked upon. Protect cables against
pinching and chafing. Pay special attention
to locations where the cables enter or exit
an enclosure or make a sharp bend.
CAUTION
Ensure that the electrical supply is protected
by overcurrent protection devices as
required by the applicable electrical codes.
4.7 Grounding
CAUTION
Be sure the equipment grounding follows
applicable electrical codes.
CAUTION
Never modify a grounded power plug to
connect to an ungrounded receptacle.
• The DXL5000 System must be connected to the common
ground on the installation.
• The ground wire should be as short as possible, and
follow the straightest path possible.
4.8 Connections
4.8.1 Transmitter Rear Panel Connectors
Refer to Figure 4-3 on page 4-6 and Tab l e 4-1 on page 4-7 for
rear panel connections to the DXL5000 System Transmitter.
4.8.2 Receiver Rear Panel Connectors
Refer to Figure 4-2 on page 4-8 and Tab l e 4-2 on page 4-8 for
rear panel connections to the DXL5000 System Receiver.
To Next Page
Loading...