Installation 4-8DXL5000 User and Technical Manual
Table 4-2: Receiver Rear Panel Connectors
WAYSIDE DATA 9-pin male D-connector
Provides RS-232 connections for SCM
operations.
See ”WAYSIDE DATA
Connections” on page 4-11 for pin-
outs.
IMC BUS 9-pin male D-connector (Reserved for future use.)
IF MON 75 ohm BNC female connector The IF MON connector provides a 70
MHz IF output for external signal
monitoring purposes.
70 MHz IF output
POWER IN AC power connector Provides AC power to the unit.
Connector Type Function Comments
MGMT RJ-45 connector
Provides 10 Base T Ethernet
connection via your web browser to a
PC at a local or remote location for
control of the unit.
See ”MGMT Connections” on
page 4-10 for pin-outs.
IF OUT 75 ohm BNC female connector The IF OUT connector provides the 70
MHz IF output from the unit.
70 MHz IF output
SUMMARY ALARM 15-pin male D-connector Provides summary alarm data for
common faults and events.
See ”SUMMARY ALARM
Connections” on page 4-10 for pin-
outs.
CHAN 1 DATA RJ-45 connector Provides 10/100 Base T Ethernet
connections to the unit.
See ”CHAN1 and CHAN2 DATA
Connections” on page 4-11 for
pinouts.
CHAN 2 DATA RJ-45 connector Provides 10/100 Base T Ethernet
connections to the unit.
See ”CHAN1 and CHAN2 DATA
Connections” on page 4-11 for
pinouts.
Table 4-1: Transmitter Rear Panel Connections (Continued)
Connector Type Function Comments
To Next Page
Loading...