MRC DXL5000 RX - Review DXL5000 System Transmitter Status

Operation 2-12DXL5000 User and Technical Manual Operation 2-12DXL5000 User and Technical Manual
2.5.1 Review DXL5000 System Transmitter
Status
To review the current DXL5000 System Transmitter status,
select the Status tab and then select the Identification tab,
Monitor Radio tab, Firmware Revisions, or Monitor Mod tab,
as required. See Figure 2-5.
Figure 2-5: Status Tab Options - Typical
Select Status Tab
Select Identification
Tab
Select Monitor
Radio Tab
Select Help Tab
Select Monitor Mod
Tab
IP Address: XXX.XXX.X.XX
Subnet Mask: YYY.YYY.YYY.Y
Default Gateway: ZZZ.ZZZ.Z.Z
Serial Number: 1234567890
Software Version: X.Y.Z
Site Name: XXXXX
Call Sign: YYYY
Date Installed: MM/DD/YY
User Information 1: XXX
User Information 2: YYY
User Information 3: ZZZ
Operating Frequency: XXXX.XX MHz
RF Output Power: 32.0 dBm
PA Voltage: 12.1
+15V: 14.9
-15V: -15.1
+5V: 4.9
System Temp: 0.0
Power Amplifier: ON
Test Tone: OFF
Symbol Rate: 20.000 Msps
Modulation: QPSK
Percent Utilization: 0.00%
Core Channel 1: none at 0.000 Mbps
Core Channel 2: none at 0.000 Mbps
Core Channel 3: none at 0.000 Mbps
Core Channel 4: none at 0.000 Mbps
Invert Spectrum: OFF
PRBS: OFF
Select Firmware
Revisions Tab
System Software: 0.50 (Build 26)
SCM PC FPGA: 3.0.0
SCM PC uP: 3.0.1
SCD PC FPGA: NA
SCD uP: NA
Radio Type: DXL 5000 Tx