Installation 4-3DXL5000 User and Technical Manual
Figure 4-1: Transmitter/Receiver Mounting - Typical
2. Install the two bottom screws first. Use lock washers
to prevent loosening. Tighten securely.
3. Install the top two screws. Use lock washers to
prevent loosening. Tighten securely.
Ventilation
CAUTION
Temperatures inside a closed mounting
area can be significantly higher than the
ambient temperature. Always allow
adequate ventilation.
• If possible, install the DXL5000 System in a climate-
controlled area.
DXL5000 TX
• Installation should allow adequate air flow around the
equipment. Air flow should be circulated and mixed with
room air, not trapped in a closed space.
• When mounting the DXL5000 System in an enclosed rack
with other equipment, it is good practice to allow spaces
at the top and bottom of the rack, and to fill those spaces
with grillwork instead of blank panels.
Moisture
WARNING
Indoor equipment is not designed to
withstand water or moisture. If water does
penetrate the chassis, it could cause
equipment damage and/or create a safety
hazard.
• Locate the equipment in an area protected from dripping
water or excessive humidity.
Cabling
Wiring is subject to extremes of temperature, humidity, and
vibration. MRC recommends the following general practices be
performed in all installations.
CAUTION Be sure the power being supplied matches
the power required by the equipment.
To Next Page
Loading...