Operation 2-22DXL5000 User and Technical Manual
Figure 2-15: Setup Tab Options - Sheet 3
Select Core
Channel menu
option required
Select Core
Channel X: DS3
BNC-1, DS3
BNC-2, E3 BNC-
1, or E3 BNC-2,
as required
Select Core
Channel X:
SMPTE BNC-3,
as required
Select Core
Channel X: T1
RJ45-1 or T1
RJ45-2 option, as
required
Select Core
Channel X: E1
RJ45-1 or E1
RJ45-2 option, as
required
Select Core
Channel X:
Ethernet RJ45-1
option, as
required
Select Core
Channel X:
RS232 or RS485
option, as
required
Select Core
Channel X: ASI
BNC-1, ASI
BNC-2, or ASI
BNC-3, as
required
Enter Data Rate
required (range is
0.064 to 90.0
Mbps)
DS3 Data Rate is
fixed (44.7360
Mbps).
E3 Data Rate is
fixed (34.3680
Mbps)
Select Cable
Length: menu
option, as
required. Options
are Under 255
feet or Over 255
feet
SMPTE Data
Rate is fixed
(19.392658
Mbps)
Ti Data Rate is
fixed (1.544
Mbps)
Select LBO:
menu option, as
required. Options
are -30 or -36
Select Channel
Coding: menu
option, as
required. Options
are Enabled or
Disabled
E1 Data Rate is
fixed (2.048
Mbps)
Select LBO:
menu option, as
required. Options
are -12 or -43
Select Channel
Coding: menu
option, as
required. Options
are Enabled or
Disabled
Select
Termination:
menu option, as
required. Options
are 75 Ohm, 100
Ohm, or 120
Ohm
Select
Termination:
menu option, as
required. Options
are 75 Ohm, 100
Ohm, or 120
Ohm
Enter Data Rate
required (range is
0.064 to 90.0
Mbps)
Select Mode:
menu option, as
required. Options
are 10 Mb/sec,
100 Mb/s, or
auto
Select Duplex:
menu option, as
required. Options
are Full or Half
Select Chain
LIU: menu
option, as
required. Options
are Enabled or
Disabled
Enter Data Rate
required (must
match Baud
Rate)
Select Baud
Rate: menu
option, as
required. Options
are 600, 1200,
2400, 4800,
9600, 14400,
19200, 28822,
38600, 52600,
115200, or
230400
Notes:
When selecting Core Channel outputs, only one connector may be
selected at a time.
For example, ASI BNC-1 and DS3 BNC-1 cannot be selected for two
Core Channel outputs. The radio BNC-1 connector can only be used
for one Core Channel output.
Core Channel X represents Core Channels 1 thru 4. Select output
options, or the none option, for Core Channel 1 thru 4, as required.
B
Note
When selecting Modulation, Core
Channel 1 thru 4, and Data Rates, the
Utilization indication should be as close
to 100% as possible.
Select Core
Channel X: none
option, as
required
From
Figure 2-14
on page 2-
21
To Next Page
Loading...