Operation 2-8DXL5000 User and Technical Manual
off and on without a minimum delay of 10 seconds between
removal of power and application of power.
Conversely, power to the DXL5000 System Receiver must never
be cycled to on and then immediately to off, as corruption of
software contained in the radio may also occur.
Power Up
The steps required to properly power up the DXL5000 System
Receiver are contained in the following steps.
CAUTION
If power is accidentally lost, do not
immediately re-apply power to the DXL5000
System Receiver.
Internal software corruption may occur if
power is applied immediately after a power
loss.
To avoid possible software corruption, wait a
minimum of 10 seconds before re-applying
power.
Note
If you are unsure of the power requirements or
connections to the DXL5000 System Receiver,
refer to the “Installation” section on page 4-1 .
Note
When the DXL5000 System Receiver is powered
up, it will automatically return to the last settings
that were in use when the unit was powered down.
1. Verify the power cable is properly connected to the
DXL5000 System rear panel AC POWER IN
connector.
2. Verify all coaxial cables and cable connectors are
properly connected to the rear panel connectors, as
applicable to your system options.
Note
The DXL5000 System Receiver does not contain a
power switch. When facility power is applied to the
DXL5000 System Receiver, the unit will power up.
3. Set the facility power source to on.
4. Verify the PC/laptop to be used to locally or remotely
control the DXL5000 System Receiver is powered up
and is connected to the MGMT RJ-45 rear panel
connector, either directly or via the internet.
5. Open Windows Internet Explorer®.
Note
In the following step, xxx.xxx.xxx.xxx is the IP
address.
6. Enter the DXL5000 System Receiver IP address as
follows:
http//xxx.xxx.xxx.xxx
7. Press the PC/laptop Enter key, and observe the
DXL5000 Log In window is displayed.
8. Enter your user name and password in the User
Name and Password text boxes and select the Log
In option button.
9. Observe the Status page Identification tab is
displayed.
To Next Page
Loading...